Dometic B3200 Guía Rápida página 13

B3200
8.3 Installing in a roof hatch opening already provided
I
NOTE
• Existing roof hatch openings in accordance with fig. 6 are suitable
for installing the roof air conditioner.
• Dispose of all waste material, glue, silicone and seals separately.
Observe the disposal guidelines.
• The manufacturer only assumes liability for parts included in the
scope of delivery. The validity of the warranty expires if the device is
installed together with third-party parts.
See fig. 7
➤ Remove all screws and fixtures of the existing roof hatch.
➤ Take out the roof hatch.
➤ Remove the sealant around the opening using a scraper or similar tool.
➤ Seal the screw holes and recesses with a flexible non-hardening butyl sealing
compound.
8.4 Laying the connecting cables
D
DANGER! Danger of electrocution
Make sure there is no voltage at electrically operated components
before carrying out work on them!
The roof air conditioner must be connected to an electric circuit which is able to sup-
ply the required current (see chapter "Technical data" on page 17).
➤ Use a cable cross section of 1.0 mm².
➤ The power must be on a separate 10 Amp time delay fuse.
➤ Feed the 230 Vw cable through the opening into the vehicle interior.
EN
Installation
11