Laying The Connecting Cables - Dometic FreshLight Instrucciones De Montaje

Dometic FreshLight
8.4

Laying the connecting cables

DANGER! Danger of electrocution
D
Make sure there is no voltage at electrically operated components
before carrying out work on them!
The roof air conditioner must be connected to an electric circuit which is able
to supply the required current (see see Chapter "Technical data" on
page 38).
➤ Select the cross-section of the cable corresponding to the length:
– Length < 7.5 m: 1.5 mm²
– Length > 7.5 m: 2.5 mm²
See fig. 9
➤ Make an opening on one side in order to feed through the electrical power
supply cable.
➤ Feed the 230 Vwcable through the opening into the vehicle interior.
If the lighting should be switched on without the use of a 230 Vwvoltage sup-
ply:
➤ Connect the cable with the positive terminal and the negative terminal of
the vehicle battery.
➤ Feed the 12 Vg cable through the opening into the vehicle interior.
8.5 Installing the roof air conditioner
Caution – risk of damage
A
Observe the structural strength of the roof of the vehicle. The roof
of the vehicle must be able to bear the weight of the roof air
conditioner. The roof must not be indented or deformed by the
weight of the unit, even over a longer period of time.
See fig. 0
➤ Lift the roof air conditioner onto the roof of the vehicle.
➤ Position the roof air conditioner over the installation opening.
Observe the direction of travel.
EN
Installation
31