Idiomas disponibles
Idiomas disponibles
Replacing the oven door (Lower oven only)
CAUTION
The door is very heavy. You may need help lifting the door high enough to slide it
into the hinge slots. Do not lift the door by the handle.
WARNING
You can't replace the upper oven door for safety reason.
A
A.
Slot in the oven cavity for the
door hinge lock
1.
Using two hands, grasp the side edges
of the door at the midpoint.
Face the oven cavity.
2.
Locate the slots on each side of the
oven cavity for the door hinge locks.
3.
Hold the door at a 45° angle, and then
align the door hinges with the slots
in the lower front of the oven cavity.
Slowly insert the door, making sure you
maintain the 45° angle. You will know
the door is engaged in the slot when
you feel a slight drop.
CAUTION
After replacing the door, make sure to reconnect the wires. Push them inward
to arrange them as they were before you removed the door. Wires that are not
connected or arranged correctly can be caught in the door or damaged by heat.
4.
Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5.
Locate the oven door hinge locks in the
corners of the oven door, and rotate the
hinge locks toward the oven cavity to
the locked position.
See Step 3 (illustration A) in the
"Removing the oven door" section for
the proper locked position.
6.
Close the oven door.
7.
When the hinges are properly installed
and the door is closed, there should be
an even gap between the door and the
control panel. If one side of the oven door
is hanging lower than the other, the hinge
on that side is not properly installed.
Reconnect the Wire Harness and then
8.
re-install the rubber cap (for the upper
oven door).
English 59
