Idiomas disponibles
Idiomas disponibles
If the meter does not turn on after replacing the battery, please check if the battery is installed correctly. If the meter still cannot be
turned on, please Eaglenos's authorized dealer.
Caution
• Turn off the meter before taking out the batteries.
• Do not remove the batteries while the meter is connected to other devices. It will affect the data transmission.
• Please dispose the old batteries in accordance with your local environmental regulations.
Code chip calibration
The code chip is a device that supplies meters with information about the characteristics of the test strips. Each box of test strips contains
a matching code chip. When using the meter for the first time or using a new batch of test strips for measurement, the old code chip must
be replaced with the code chip from the new test strip package.
Illustrations
Steps
Step 1: When the meter is turned off,
insert the code chip from the new
test strip package into the meter.
The meter will automatically turn
on and display the calibration
code. Compare the calibration
code displayed with the one on the
package. If they are the same, then
the calibration is successful. Remove
the code chip.
Illustrations
Front end of the
test strip slot
Dividing line of a
test strip
Steps
Step 2: Insert the test strip with the
logo side up into the test strip slot
and push it all the way in until you
hear a "beep" sound.
www.laktate.com | 45
