Mitsubishi Electric CITY MULTI PKFY-P24NKMU-E2 Manual De Instrucciones página 7

5. Operation
5.5. Airflow up/down direction setting
<To change the airflow up/down direction>
With the unit running, press the Airflow up/down button
necessary.
• Each press changes the direction. The current direction is shown at
.
• The change sequence, and the available settings, are as follows.
Airflow
Swing Auto
5 steps
model*1
Swing
4 steps
* Note that during swing operation, the directional indication on the
screen does not change in sync with the directional vanes on the
unit.
* Some models do not support directional settings.
*1. The 5 steps model may not be supported depending on the model
of remote controller and system controller.
Other remote controllers display the same as 4 steps model.
*2. Air flow direction setting <Auto>
COOL/FAN/DRY: Setting 1 (Horizontal), HEAT: Setting 5 (Down
ward 5)
Note:
Available directions depend on the type of unit connected. Note also that
some units do not provide an "Auto" setting.
In the following cases, the actual air direction will differ from the direction
indicated on the remote controller display.
1. While the display is showing "STAND BY" or "DEFROST".
2. Immediately after starting heater mode (while the system
is waiting for the operation mode change to take effect).
3. In heat mode, when room temperature is higher than the
temperature setting.
<[Manual] To Change the Airflow's Left/Right Direction>
* The louver button cannot be used.
Model PKFY-P·NKMU-E2
• Stop the unit operation, hold the lever of the louver, and adjust to
the desired direction.
* Do not set to the inside direction when the unit is in the cooling or
drying mode because there is a risk of condensation and water
dripping.
Caution:
To prevent falls, maintain a stable footing when operating the unit.
as
Display
1 2 3 4 5
1 2 3 4
5.6. Ventillation
For LOSSNAY combination
5.6.1. For Wired Remote-controller
To run the ventilator together with the indoor unit:
Press the ON/OFF button
• The Vent indication appears on the screen (at
will now automatically operate whenever the indoor unit is running.
To run the ventilator only when the indoor unit is off:
Press the Ventilation button
• The On lamp (at ) and the Vent indication (at
To change the ventilator force:
Press the Ventilation button
• Each press toggles the setting, as shown below.
(Low) (High)
Note:
With some model configurations, the fan on the indoor unit may come on
even when you set the ventilator to run independently.
.
). The ventilator
while the indoor unit is off.
) come on.
as necessary.
No display
(Stop)
(OFF)
7