Stihl MS 192 Manual De Instrucciones página 44

Idiomas disponibles

Idiomas disponibles

English
Checking the Chain
Sprocket
Disengage the chain brake: Pull the
N
hand guard toward the front handle.
Remove the chain sprocket cover,
N
chain and guide bar.
Replace the chain sprocket
after using two saw chains or
sooner
if the wear marks (arrows) on the
sprocket are deeper than approx.
0.02 in (0.5 mm) since this would
reduce the life of the chain. You can
use a gauge (special accessory) to
check the depth of the wear marks.
It is best to use two saw chains in
rotation with one sprocket.
STIHL recommends the use of original
STIHL sprockets to ensure correct
operation of the chain brake.
Have the chain sprocket replaced by a
servicing dealer. STIHL recommends
that you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
42
Maintaining and
Sharpening the Saw Chain
Sawing effortlessly with a properly
sharpened saw chain
A properly sharpened saw chain cuts
through wood effortlessly even with very
little pushing.
Never use a dull or damaged saw chain
– this leads to increased physical strain,
increased vibration load, unsatisfactory
cutting results and increased wear.
Clean the saw chain
N
Check the saw chain for cracks and
N
damaged rivets
Replace damaged or worn chain
N
components and adapt these parts
to the remaining parts in terms of
shape and level of wear – rework
accordingly
Carbide-tipped (Duro) saw chains are
especially wear-resistant. For an optimal
sharpening result, STIHL recommends
STIHL servicing dealers.
Compliance with the angles and
dimensions listed below is
absolutely necessary. An
improperly sharpened saw chain –
especially depth gauges that are
too low – can lead to increased
kickback tendency of the chain
saw – risk of injury!
Chain pitch
The chain pitch marking (a) is embossed
in the area of the depth gauge of each
cutter.
Marking (a)
Chain pitch
Inches
7
1/4 P
1 or 1/4
1/4
6, P or PM
3/8 P
2 or 325
0.325
3 or 3/8
3/8
4 or 404
0.404
The diameter of file to be used depends
on the chain pitch – see table
"Sharpening tools".
The angles of the cutter must be
maintained during resharpening.
a
mm
6.35
6.35
9.32
8.25
9.32
10.26
MS 192 C
loading