Idiomas disponibles
Idiomas disponibles
When the engine begins to fire.
4
If the engine is cold:
Set the choke lever (4) to j and
N
continue cranking until the engine
runs.
If the engine is warm
Continue cranking until the engine
N
runs.
As soon as the engine runs
3
2
Blip the throttle trigger (2) the
N
Master Control lever (3) moves to
the run position F and the engine
settles down to idling speed.
As the chain brake is still
engaged, the engine must be
returned to idling speed
immediately or the engine housing
and chain brake might otherwise
be damaged.
MS 192 C
Pull the hand guard back toward the
N
handlebar. The chain brake is now
disengaged – your saw is ready for
operation.
Always disengage chain brake
before accelerating the engine.
High revs with the chain brake
engaged (chain locked) will
quickly damage the powerhead
and chain drive (clutch, chain
brake).
Always check operation of chain
N
lubrication before starting work.
At very low outside temperatures
Allow engine to warm up at part
N
throttle.
Shut off the engine
Move the Master Control lever to 0
N
or STOP.
If the engine does not start
If fuel tank has been run completely
dry and then refueled
After refueling, press the fuel pump
N
bulb at least five times – even if the
bulb is filled with fuel.
Engine is flooded
If you did not move the choke lever to
warm start j quickly enough after the
engine began to fire, the combustion
chamber is flooded.
Move the Master Control lever to 0
N
or STOP.
4
Insert a suitable tool in the spark
N
plug boot (4).
Pry off the spark plug boot.
N
Unscrew and dry off the spark plug.
N
Open the throttle wide.
N
Set the choke lever to j.
N
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Install the spark plug and connect
N
the spark plug boot, press it down
firmly – reassemble the other parts.
Set the Master Control lever to n –
N
the starting throttle position.
English
33
