Dometic PW 3500 Instrucciones De Uso página 19

PR4500
Step 2: Programme the wind sensor
➤ Turn the knob for setting the sensitivity (fig. 6 2, page 4) to "0".
➤ Press the programming button in the battery compartment of the remote control
(fig. 3 2, page 3).
✓ The receiver beeps once briefly.
✓ The awning moves twice briefly.
➤ Press the programming button directly afterwards in the battery compartment of
the remote control (fig. 3 2, page 3).
✓ The receiver beeps once briefly.
➤ Press the programming button on the wind sensor (fig. 6 1, page 4) once
briefly.
✓ The sensor beeps once briefly.
✓ The awning moves twice briefly.
✓ The receiver beeps five times briefly.
✓ The wind sensor is now linked to the awning.
➤ Turn the knob for setting the sensitivity (fig. 6 2, page 4) to "3".
Step 3: Insert the wind sensor and sensor unit and check the sensor
➤ Insert the sensor unit in the housing.
➤ Install the wind sensor on the inside of the front panel.
➤ Test the wind sensor by moving the front panel approx. 10 cm up and down
quickly in the middle for 8 seconds (fig. 4, page 3).
✓ The awning retracts.
The wind sensor is correctly programmed and the procedure is complete.
➤ If the awning fails to retract, repeat the programming.
EN
Adjusting the awning
19