Dometic PW 3500 Instrucciones De Uso página 17

PR4500
6.7 Closing the awning manually in emergencies
If the awning is damaged, the motor is faulty or the power supply is unavailable, the
awning can be closed manually.
To do this, you need the following tools:
• Screwdriver
• 10-mm open-ended or ring spanner.
!
WARNING!
Disconnect the awning from the power before you start the procedure.
Otherwise the awning could start working again unexpectedly. The
awning motor could rotate the hexagonal shaft causing the tool to spin
uncontrollably and lead to serious injury or cause serious damage to
your vehicle.
➤ Undo the screw (fig. 7 2, page 5) with a screwdriver and remove the cover cap
(fig. 7 1, page 5).
➤ Turn the hexagonal shaft (fig. 8 1, page 5) anti-clockwise with a 10 mm
open-ended or ring spanner, until the awning is fully retracted.
I NOTE
• Due to its design, the awning is not able to retract as far manually, as
it can in the electric mode. A gap remains between the front cover
and the housing. This does not affect safety.
• When the awning has been retracted manually, the settings are no
longer correct. After repair, the awning needs to be reset, see
chapter "Resetting the motor and remote control" on page 20.
➤ Put on the left-hand cap.
➤ Contact the service partner in the respective country to get the awning repaired.
6.8 Switching the LED light on and off (accessory)
If the awning is fitted with an LED light (max. 30 W), you can use the remote control
to switch the light on and off as follows:
➤ Press the
button to switch on the LED light.
➤ Press the
button again to switch off the LED light.
EN
Operating the awning
17