Installing The Microphone; Steering Column - Pioneer SPH-T20BT Manual De Instrucciones

Installation using
the screw holes
on the side of this
product
1
Fastening this product to the
radio-mounting bracket.
Position this product so that its
screw holes are aligned with the
screw holes of the bracket, and
tighten the screws at 3 locations on
each side.
Radio-mounting bracket
If the pawl interferes with
installation, you may bend it
down out of the way.
Dashboard or console
Truss screw
Be sure to use the screws
supplied with this product.
14
En
KM954ES.indb 14
Installing the
microphone
The microphone should be placed
directly in front of the driver at a
suitable distance to pick up their
voice clearly.
CAUTION
It is extremely dangerous to allow
the microphone lead to become
wound around the steering column
or shift lever. Be sure to install the
microphone in such a way that
it will not obstruct driving. It is
recommended to use the clamps
(sold separately) to arrange the
lead.
NOTE
Depending on the vehicle model,
the microphone cable length may
be too short when you mount the
microphone on the sun visor. In
such cases, install the microphone
on the steering column.
To install on the sun
visor
1
Fit the microphone lead into
the groove.
Microphone lead
Groove
2
Install the microphone clip
on the sun visor.
Lowering the sun visor reduces
the voice recognition rate.
Microphone clip
To install on the

steering column

1
Slide the microphone
base to detach it from the
microphone clip.
Microphone
Microphone clip
Microphone base
2
Install the microphone on
the rear side of the steering
column.
Double-sided tape
2019/11/6 10:20:01