Idiomas disponibles
Idiomas disponibles
EN
Oiler Adjustment
Adjustment is made at the factory and should not be changed unless lubricating diffi culties are
experienced. If adjustment becomes necessary, remove the Hammer Case Bolts and Backhead
Cap Screws and holding the Motor Housing onto the Gear Case and remove the Housing. A small
Adjusting Hole Plug is located in the Housing's front face. Remove this Plug, as well as a similar
Plug on the side of the Housing. The Adjusting Screws are located beneath the Plugs. Turn the
Oiler Adjusting Screws with a small screwdriver. Turning the Screws in reduces the oil fl ow;
backing the Screws out increases the oil fl ow. Two Oiler Felts are located under each Screw.
After long usage, these Felts may become clogged, preventing the passage of oil. If this happens,
remove the Plugs and Screws and replace the Felts.
Governor Adjustment
The drawing TPD497 on page 2, illustrates the sensitive weight-type Governor which controls
the speed of the Multi-Vane motor. It is adjusted at the factory to produce a socket speed of
approximately 355 rpm. It is seldom necessary to change this adjustment. However, if the
free speed of the square driver is checked with a techometer and is not within 5 rpm of the
recommended speed of 355 rpm, steps should be taken to correct it. Screwing the adjusting nut
farther onto the governor stem increases the speed; backing the nut off decreases the speed,
One-half turn of the nut will vary the socket speed about 5 rpm.
When installing a new Governor, set the Nut so that dimension "A" is "1-3/4" (44 mm). This usually
produces an allowable speed.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi ce or Distributor.
EN-2
03523865_ed7
