Service Information - Black and Decker BDSG500 Manual De Instrucciones

Ocultar thumbs

Contenido

página de 22

/ 22
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

20 • ENGLISH

Notes:

a. The depth stop is a press fit onto the depth adjuster (2).

Simply twist and pull outward to slide it off

the depth adjuster.

b. You can also turn the depth adjuster clockwise to

expose the screwdriver bit. This however will cause

you to lose the depth setting and you will have

to re-set the depth.

MAINTENANCE

Keep guards, air vents and the motor housing as clear as

possible of dust and dirt. Wipe with a clean cloth and blow

through with a low-pressure air supply. Excessive build-up of

metal dust can cause tracking of electrical current from the

internal parts to exposed metal parts. Do not overload your

angle grinder. Overloading causes a reduction in speed and

efficiency, causing your angle grinder to become too hot. If

this happens, operate your angle grinder under no load for

one or two minutes until it has cooled to normal operating

temperature. Switching your angle grinder off under load will

reduce the life of the switch.

Warning! When servicing, use only identical replacement

parts. The use of any other part may create a hazard or

cause product damage.

f DO NOT use solvents when cleaning plastic parts.

Plastics are susceptible to damage from various types

of commercial solvents and may be damaged by their use.

Use a clean cloth to remove dirt, dust, oil, grease etc.

Warning! Do not allow brake fluids, gasoline,

petroleum-based products, penetrating oils, etc. to come

into contact with plastic parts. They contain chemicals that

can damage, weaken or destroy plastic.

f Remove accumulated dust and debris regularly using

a SOFT and DRY brush.

Warning! Use safety goggles when using an air jet

to blow dust out of the tool. Keep air vents clean and

unobstructed to allow maximum airflow through the tool.

f DO NOT abuse power tools. Abusive practices can

damage the tool and the workpiece.

Warning! DO NOT attempt to modify tools or create

accessories. Any such alteration or modification is misuse

and could result in a hazardous condition leading to

possible serious injury. It will also void the warranty.

LUBRICATION

All of the bearings in this tool are lubricated with a

sufficient amount of high-grade lubricant for the life of

the unit under normal conditions. Therefore, no further

lubrication is required.

CLEANING

Use only mild soap and a slightly damp cloth to clean your

angle grinder. Many household cleaners contain chemicals

which could seriously damage the plastic. Also, do not

use petrol, turpentine, lacquer or paint thinners or similar

products. Never let any liquid get inside the tool and never

immerse any part of the tool into liquid.

Important! To assure product SAFETY and RELIABILITY,

repairs, maintenance and adjustment (other than those

listed in this manual) should be performed by authorized

service centers or other qualified service personnel,

always using identical replacement parts.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be

disposed of with normal household waste.

Should you find one day that your Black & Decker

product needs replacement, or if it is of no further

use to you, do not dispose of it with household waste.

Make this product available for separate collection.

Separate collection of used products and packaging

allows materials to be recycled and used again.

Re-use of recycled materials helps prevent

environmental pollution and reduces the demand

for raw materials. Local regulations may provide for

separate collection of electrical products from the

household, at municipal waste sites or by the

retailer when you purchase a new product.