Idiomas disponibles
Idiomas disponibles
Riding mower High Speed Tracking
1.
If the riding mower tracks to one side with both drive control levers fully
forward, adjust the control levers as follows:
2.
Check for proper and balanced air pressure in both front and rear tires. Refill
tires if necessary.
3.
Perform the first three steps in the previous sub-section, Riding mower
Creeping, to verify that the riding mower is not creeping. If creeping, adjust
following the instructions in that sub-section.
4.
Recheck the tracking after making any adjustments to the transmission
control rods.
5.
If uneven tracking persists, note which direction the riding mower is
tracking.
6.
If the riding mower tracks to the right, adjust the control lever stop bolt on
the left side.
7.
If the riding mower tracks to the left, adjust the control lever stop bolt on the
right side.
8.
Locate the applicable stop bolt on the left or right console. See Figure 45.
Jam Nut
9.
Loosen the jam nut on the stop bolt, then turn the stop bolt
counterclockwise to make it longer. Recheck the tracking and fine tune the
adjustment as necessary.
NOTE: If the stop bolt is adjusted too far, the tracking problem will change
sides. Make fine tuning adjustments by shortening the same bolt.
10.
Tighten the jam nut against the console and reposition the control lever as
necessary to make the two control handles even with each other.
SERVICE AND MAINTENANCE
Console
Stop Bolt
Figure 45
34
