Idiomas disponibles
Idiomas disponibles
BELT CHANGING AND BRUSHROLL CLEANING
TO CLEAN BRUSHROLL:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your
vacuum cleaner, the brushroll must be
cleaned every time the belt is changed.
The brushroll must also be cleaned
according to the following schedule:
Vacuum Cleaner Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time/week)
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up in the PowerMate
brushroll and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush unit area.
Carefully remove any string wound onto
the brushroll and end caps.
BRUSHROLL ASSEMBLY
End Cap
Brush Unit
Clean Brushroll
every week
every month
every 2 months
®
Belt Path
End Cap
- 24 -
TO REPLACE BELT
1. Install new belt over motor drive, then
over belt path.
NOTE: See REPLACEMENT PARTS for part
number and purchase details (page 6).
Belt
Belt Path
2. Place brushroll assembly back into
®
PowerMate
.
3. Line up front of cover and base. Rest
cover on front edge of base as shown.
4. Rotate cover back. Press cover firmly
until side and rear latches snap into
place.
NOTE: Make sure there is no gap between
the cover and base.
5. Turn PowerMate
replace four (4) cover screws.
Brushroll
Motor
Shaft
End
Cap
Cover
Base
®
upside down and
