Idiomas disponibles
Idiomas disponibles
English
1
Fig. 5
Proceed as follows for wall mounting:
1. Mount the wall bracket, aligning it using a spirit
level. Use the special washers supplied, as well as
the screws and screw anchors suitable for the wall
in question.
Screws and screw anchors are
not included in the supply scope.
2. Hang the charging system into the mounted wall
anchor and mark the hole locations for the lower
fastening screws.
28
Wall mounting
2
3
11 kg
4
5
1 7 2 m
m
900 – 1,500 mm
3. Take the charging system out again and drill holes at
the markings.
4. Insert all cables through the rear of the charger and
through the designated grommets. Insert any LAN
cable without the LAN connecting plug.
5. Hang the charging system into the wall bracket again
and fasten it in place. Use the supplied washers.
6
7
274 mm
