Idiomas disponibles
Idiomas disponibles
6. Turn the control cage (B) counterclockwise, if the
hotspot is too much on the left side.
7. Make sure that the hotspot is equaly applied on the
surface for correct adjustment.
8. Tighten the cage clamps when the control cage is in
correct position.
18
9. Attach the feedspout and put the rubber seal on to
the tube.
A
To stop the product
1. Push the abrasive control cable to close the abrasive
To operate the abrasive valve on
valve. Refer to
page 11 .
2. Push the OFF button to stop the blast motor.
3. Turn the ON/OFF switch to OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust extractor. Refer to the operator's
manual of the dust extractor.
2014 - 001 - 07.02.2023
