Idiomas disponibles
Idiomas disponibles
Gas connec-
tor in torch
Negative
quick connector
Output wiring drawing
Out put connecting under MMA model
Connecting the cable the "-" in font panel and
tighten up, the other end connecting to the work
piece.
"-" connecting
work piece
Operation
1
2
3
12
11
1. Welding mode selection switch
2. Dc/pulse select switch
3. Steps 2/4 option switch
4. Digital meter
5. Power indicator
6. Overvoltage and under-voltage indicator
7. Over heat indicator
8. Parameter setting knob
9. Connector for Torch Control
10. Socket "+"
11. Socket "-"
12. Gas connector for torch
13. Power switch
14. Power core
15. Gas connector
Positive quick
connector
Control cable
in torch
"+" connect-
ing electrode
holder
4
5
6
13
7
8
9
10
ATTENTION
• The 'Protection Indicator' on the panel will be
on after a long time operation, it shows that the
inner temperature is over the permitted data. The
machine should be stopped using for some time
to let it cool down. It can continually use after the
light is off.
• The power source, Argon valve and cooling
water should be switch off after the operation or
leaving job site temporarily.
• Welders should dress canvas work suit and wear
mask to prevent arc light and thermal radiation;
• Light separating screen should be put in the job
site to prevent arc hurting other people;
• Inflammable or explosive materials are prohibited
to access the job site;
• Every connector of welder should be connected
correctly and grounded reliably
• Manual Arc Welding
When put 'welding mode selection switch' on
'arc welding' and Dc/pulse select switch on DC
position, it can be used as manual arc welding.
Choose Parameter setting knob enter into welding
current parameter setting to adjust welding cur-
rent and also can enter into pushing force current
parameter setting to adjust pushing force current.
14
DC TIG Welding
• When put welding mode selection switch on Tig
welding and put DC/ pulse select switch on DC
position, Put Steps 2/4 option switch on step 2, it
can be used as DC TIG Welding.
• Choose Parameter setting knob enter into weld-
15
ing current parameter setting to adjust welding
current and also can enter into current increasing
time parameter setting to adjust increasing time,
enter into current decreasing time parameter set-
ting to adjust decreasing time.
• Choose Parameter setting knob enter into Post-
flow Time parameter setting to adjust Postflow
Time.
• Choose Parameter setting knob enter into Preflow
Time parameter setting to adjust Preflow Time
DC Pulse TIG Welding
• When put welding mode selection switch on Tig
welding and put DC/ pulse select switch on DC
position, Put Steps 2/4 option switch on step 2, it
can be used as Pulse TIG Welding
• Choose Parameter setting knob enter into pulse
welding current parameter setting to adjust Pulse
welding current.
• Choose Parameter setting knob enter into Pulse
background current parameter setting to adjust
Pulse background current.
25
