Oscartielle MARTE 2 Serie Instrucciones De Uso página 28

About one hour after switching the cabinet on, you can start filling it with products. Always check that the temperature
reading on the display of the electronic control is suitable for the conservation of the products placed in the display
cabinet, namely +65°C for the most part of the foods. This temperature may continue the cooking of some kind of food, so
it is advisable to display small quantities of products during slow sales time.
The cabinet is designed for the display of food products, which are stored at the temperature of the product. It should not
keep them hot or cook them. The products must be displayed after cooking and at at a storage temperature eual and not
lower than +65°C.
Warning: Do not touch the inside parts of the cabinet used for heating.
Warning: Unplug at the mains before cleaning and wait until the warm components are cold.
Any liquid coming from dislayed food sould be immediately cleaned with a wet cloth. Please pay special attention to
glasses.
Clean the unit on a regular basis with neutral soap and then dry with a soft cloth. Never use flammable or abrasive
products. Never clean the unit with direct jets of water. When cleaning the inside of the unit, always wear protective
gloves.
Avoid that top lightings, electrical wiring and all electrical equipment are wet during cleaning operations.
Warning: Only plug the unit back in after checking that all parts (extracted or otherwise) are dry. Reload the unit following
the instructions in point 8.
Warning: If the unit doesn't keep the products warm enough:
- Check that the unit has been loaded properly; otherwise, see point 8.
- Check that the unit is not close to strong air flows (see point 4).
- Check that the unit is levelled and that the environmental conditions meet those indicated in point 4.
If the problem persists despite the above checks, contact your nearest service centre.
Warning: Never approach the cabinet in the event fire. Unplug at the mains. Never use water to put out any flames, but
only CO extinguishers.
2
15 - Accessories
Marte 2 cabinets can be equipped with the following accessories on request:
- High and low dividers
- Stainless steel 1 and 2 steps display shelves
- Front lighting
- Intermediate shelf and its lighting kit
- Bags rest
- Rear sliding doors
- Socket-holder kit
- Speed fan regulator
- Working shelf extension
- Cutting board
- Plexiglas wrapping board
- Stainless steel paper holder
- Electric defrosting kit.
If you are interested in purchasing any of the above accessories, please contact your nearest dealer or the manufacturer
directly. Only qualified personnel should assemble the electric defrosting units.
16 - Service
If you require the services of an expert, and whenever you have to replace mechanical, electrical or compressors, the
user can contact the distributor where the cabinet was purchased, to order original spare parts.
17 - Dismantling and elimination of cabinet
For environmental reasons and in compliance with the regulations in your country, separate the parts of the cabinet for
disposal and/or recycling.
All the parts that make up the cabinet are made of materials that are not classifiable as urban waste except for the
metallic parts that are not classified as special waste in most countries. As regards the parts of the refrigeration circuit,
that is the refrigerating gas and lubricating oil, these should not be disposed of carelessly and can be recycled by
specialized centers.
This product contains HFC, namely fluoridated gasses, a refrigerating gas with a high Global Warming Potential
(GWP) regulated by the Kyoto protocol.
The gas contained in foam polystyrene for thermal insulation of the cabinet is (CO
Oscartielle equips its plug-in cabinets with the following types of refrigerating gasses:
R290; GWP = 3
(100)
R 134A; GWP = 1300
(100)
R 452A; GWP = 2140
(100)
R 404A; GWP = 3750
(100)
This unit is hermetically sealed and the refrigerating gas load is under 3 kg.
26
).
2