Idiomas disponibles
Idiomas disponibles
Before use
Charging the appliance battery
(see fig. A)
NOTE
►
The battery is supplied partially charged.
Before first use, charge the battery in the
charger for at least 1 hours. This guarantees
full battery power. Li-ion batteries can be
charged at any time without adversely
affecting their service life. Interruption of the
charging process will not damage the
battery.
►
If the battery charge level indicator
up red during use, the battery is at less than
30% of its capacity and needs to be
charged.
►
Never charge the cordless appliance when
the ambient temperature is below 10°C or
above 40°C. If a lithium-ion battery is to be
stored for an extended period, the charge
level should be checked regularly. The
optimum charge level is between 50% and
80%. The storage climate should be cool and
dry and the ambient temperature should be
between 0°C and 50°C.
Start charging:
♦
Connect the charger
50/60 Hz power source.
♦
Connect the charger
on the device.
The battery is fully charged when the battery level
indication
changes from red to green.
Stop charging:
♦
Disconnect the charger
power supply.
♦
Disconnect the charger
socket
on the device.
PAS 4 A1
lights
to a 100–240 V ∼
to the charging socket
from the mains
from the charging
Assemble the attachments
Usage:
- With the torque attachment
soon as the screw is tight. Set the required torque
from one of the 10 levels.
- The eccentric attachment
even in locations that are close to the wall.
- The angle attachment
right angles.
- The cutting attachment
materials, such as card and similar materials up to
a thickness of 6 mm.
Assembly:
NOTE
►
Before carrying out any work on the appli-
ance, ensure that the rotation direction switch
is in the middle. This prevents unintentional
switching on.
♦
Start by removing the rubber cap from the tool
holder (see fig. B).
♦
Now you can fit the supplied attachments to the
appliance. To do this, fit the attachment onto
the appliance and turn it in the direction of the
arrow so that the attachment clicks into place
(see fig. C, example torque attachment
Dismantling:
♦
To remove the attachments from the appliance,
press the locking button
ment away from the arrow. Now the attachment
can be pulled forwards and off the appliance.
♦
Afterwards, replace the rubber cap on the tool
holder.
Changing bits/screw driver bits
(see fig. D)
Inserting:
♦
Insert the bit into the tool holder
Removal:
♦
Pull the bit out of the tool holder
screwing stops as
allows you to screw
allows you to screw at
allows you to cut soft
).
and turn the attach-
.
.
GB│MT
43
│
■
