Tabla de contenido
Idiomas disponibles
Idiomas disponibles
General safety advice for electrical power tools / Before first use
or lack of experience and knowledge if they have
been given supervision or instruction concerning
use of the appliance in a safe way and under-
stand the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
The charger is only suitable for
indoor use.
Attention - Service lines!
Take steps to ensure that
you do not hit upon any service lines
(electricity, gas, water) when working
with electrical appliances. Check, if need be
with a service line detector, before you start to cut
or bore into a surface.
Original ancillaries /
accessories
Use only the ancillaries and accessories
that are detailed in the operating in-
structions. The use of ancillaries and acces-
sories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.
Before first use
Removing / charging / inserting
rechargeable battery pack
Note: The battery is supplied partially charged.
Charge the rechargeable battery in the charging
station for at least one hour before first use. By doing
this the battery will operate at its highest capacity.
You can charge the Li-Ion battery at any time with-
out risk of shortening battery life. Interrupting the
charging process does not damage the battery.
40 GB/MT
1. In order to remove the rechargeable battery pack
, press the release buttons
7
rechargeable battery pack
2. Insert the rechargeable battery pack
quick-charger
.
14
3. Insert the mains plug into the mains socket.
The indicator LED
12
4. The green charge indicator LED
that the charging process is complete and the
battery pack
is ready for use.
7
5. Insert the rechargeable battery pack
the device.
Checking the battery status
To check the battery status, press the button for
the rechargeable battery LED
diagram). The status or the remaining power
will be displayed in the rechargeable battery
LED
as follows:
3
RED / ORANGE / GREEN = maximum charge /
performance
RED / ORANGE = medium charge / performance
RED = low charge – recharge battery
Changing tools
Your cordless drill / screwdriver has a fully automat-
ic spindle lock
.
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch
2 Gear Drive
Note: Move the gear selector switch
the device has come to a standstill.
and take the
8
out of the device.
7
into the
7
illuminates red.
shows you
13
into
7
(refer to main
2
can
11
.
, you can immedi-
).
5
only after
1
Capítulos
Tabla de contenido
