Original Ancillaries / Accessories; Before First Use; Charging The Rechargeable Battery On The Device (See Fig. D); Changing The Bits / Screwdriver Bit Inserts - Parkside PAS 3.6 A1 Instrucciones De Utilización Y De Seguridad

General safety advice for ... / Before first use / Preparing the tool for use
switch is in the middle position (lock).
To prevent the device from starting up uninten-
tionally.
©

Original ancillaries / accessories

½
Use only the ancillaries and accessories
that are detailed in the operating
instructions. The use of ancillaries and ac-
cessories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.
©
Before first use
©
Charging the rechargeable
battery on the device
(see Fig. D)
Note: The battery is supplied partially charged.
Charge the battery for at least three hours before
first use. You can charge the Li-Ion battery at any
time without risk of shortening battery life. Interrupt-
ing the charging process does not damage the
battery.
Starting the charging process:
Connect the mains adapter
50 Hz mains socket.
Connect the mains adapter
socket on the device
The rechargeable battery is charged when the
battery indicator
3
Ending the charging process:
Disconnect the mains adapter
mains socket.
Disconnect the mains adapter
charging socket on the device
©
Changing the bits /
screwdriver bit inserts
Insertion:
Insert the bit directly into the tool holder
34 GB/MT
All manuals and user guides at all-guides.com
10 to a 230 - 240 V ~
to the charging
10
5 .
changes from red to green.
10 from the
from the
10
5 .
.
9
Removal:
Pull out the bit out of the tool holder
©

Preparing the tool for use

©
Switching on / off the
cordless screwdriver
Switching on:
To start the appliance squeeze on the ON /
OFF switch and then keep it pressed down.
7
Switching off:
To stop the appliance, release the ON / OFF
switch .
7
©
Changing the
direction of rotation
Clockwise:
Slide the direction of rotation switch
left.
Press the ON / OFF switch
indicator (clockwise)
now screw in the screws.
Anticlockwise:
Slide the direction of rotation switch
right.
Press the ON / OFF switch
dicator (anticlockwise)
now screw out the screws.
Lock:
Slide the direction of rotation switch
the middle position. The ON / OFF switch
is now locked.
©
Switching on / off the
LED lights
8
Switching on:
Press the ON / OFF switch (LED lights)
keep it pressed.
.
9
to the
1
7 . The direction
illuminates. You can
2
1 to the
. The direction in-
7
4 illuminates. You can
into
1
7
6 and