Idiomas disponibles
Idiomas disponibles
3.3.4
Taking measurements
Prepare the surface to be measured - it should be cleaned of any
additional solid impurities that could affect the measurement result.
Turn on the device with the probe at least 2 cm away from the surface
to be measured. Touch the surface to be measured with the probe
until its tip retracts into the housing - at this time the device will
measure the coating and the obtained result will be indicated by a
short sound. Then move the probe tip at least 2 cm away from the
surface to be measured. If necessary, subsequent measurements can
be made following the same steps.
3.4.
Cleaning and maintenance
a)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
b)
Do not spray the device with a stream of water or immerse it in water.
c)
Make sure that no water enters through the ventilation openings in the casing.
d)
Use a soft cloth for cleaning.
e)
Do not leave the batteries in the device when it will not be used for a long time.
f)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the
device is made.
g)
Do not clean the device with acidic substances, medical products, thinners,
fuel, oil or other chemicals as this may damage the device.
INSTRUCTIONS FOR THE SAFE DISPOSAL OF BATTERIES.
The devices are equipped with AAA 1.5V batteries.
Remove used batteries from the device in the same way you put them in. Return
the batteries to a device responsible for their disposal.
assigned to "Batch (Car)" returns to the previous batch
(vehicle).
On the measurement interface, briefly pressing the button
assigned to "Group" will move to the next measurement
group. Pressing and holding down the button assigned to the
"Group" function will return to the previous measurement
group.
On the measurement interface, pressing and holding down
the button assigned to "Delete" function will delete the
measurement data of the group.
