Idiomas disponibles
Idiomas disponibles
INSTALLATION MANUAL
DECORATIVE ELECTRIC PUMPS
1. SAFETY STANDARS
MULTI 800, MULTI 1300, MULTI 2500, MULTI 4000, MULTI 5800
Check that the voltage recorded on the pump corresponds to the mains voltage. The device
shall be powered through a differential switch (life-saving), whose rated current shall be less
than or equal to 30mA.
The pump can operate in "Wet&Dry" mode (submerged or out of water, with the exception of
model 800 which operates only in submerged in water).
The pump must not operate dry or with liquids whose temperature exceeds 95F/35°C!
Before carrying out any work on the pump, the power supply must always be disconnected. It
is not possible to replace the power supply cable of the pump and if it is damaged, the device
must be demolished. This product complies with current safety standards.
2. INSTALLATION
Install the pump taking care that the cable is routed in an area where it will not be damaged.
Mod. 800
The water flow rate is regulated by means of the corresponding adjustment element A (fig. 1)
mounted both on the model with front panel and on the model with elongated pre-chamber. The
pump is ready to be connected to 1/2" pipes and fittings.
Mod. 1300 version with front panel
The pump is threaded on the delivery side only and can be fitted with commercially available
1/2" fittings and accessories.
On the suction side, a front panel with adjustment A (fig. 2) allows the flow rate and discharge
head of the pump to be varied.
Mod. 1300 - 2500 - 4000 - 5800 version with elongated pre-chamber.
The pump is threaded both at suction and delivery: mod. 1200 1/2"; mod. 4000HH 3/4" at
delivery and 1" at suction; mod. 3000 - 4000 - 5000 - 6000 1". The thread has a standard GAS
(Europe) or MTP (USA) pitch, which allows a wide range of fittings and accessories to be
available on the market.
www.proindecsa.com / [email protected]
9
ENG
