Pump Performance; Starting The Engine - Honda WMP20XE Manual Del Propietário

PUMP PERFORMANCE

The maximum pump discharge capacity is determined when pumping
clear water at 0 meters total head and at sea level. As the total head
[1] (discharge head [2] + suction head [3]) increases, pump discharge
capacity decreases (see figure). If the pump is used at higher
elevations, pump discharge capacity may also decrease. Other
factors affecting pump discharge capacity are:
• The type of chemical being pumped.
• The length and type of the suction and discharge hose used.
[2]
[3]
Pump Performance (Maximum with clear water)
Total head [1]
Suction head [3]
Discharge capacity
Self-priming time
Pressure
Oil Alert® System
The Oil Alert system is designed to prevent engine damage caused by
an insufficient amount of oil in the crankcase. Before the oil level in
the crankcase can fall below a safe limit, the Oil Alert system will
automatically shut down the engine (the ignition switch will remain in
the ON position).
If the engine stops and will not restart, check the oil level (page 8)
before troubleshooting in other areas.
6

STARTING THE ENGINE

1. Turn the fuel valve [1] to
2. Move the choke lever [2]
[1]
3. Turn the ignition switch
32 m
8 m
833 l/min
65 sec at 5 m
310 kPa
4. Move the throttle lever
5. Pull the starter grip
6. As the engine warms
ENGLISH
the ON position.
to the CLOSED position.
Do not use the choke if
the engine is warm or
the ambient
temperature is high.
[3] to the ON position.
[4] slightly to the left.
lightly until resistance is
felt, then pull it briskly.
NOTICE
Return the starter grip
slowly back to the engine to prevent damage to the starter.
up, gradually move the
choke lever [5] to the
OPEN position.
[1]
ON
[2]
CLOSED
[3]
[4]
[5]
OPEN
ON