Idiomas disponibles
Idiomas disponibles
Downloaded by: pd-oliana on 04-04-2023 14:43 CEST
EN
(Original instructions)
FA008
STAND FAN
DESCRIPCIÓN
1. Front guard
2. Net Hoop
3. Blade Cap
4. Fan Blade
5. Locking Nut
6. Rear guard
7. Motor Spindle
8. Motor
9. Fan Control Box
10. Set screw
11. Inner Pipe
12. Height adjustment lock nut
13. Outer Pipe
14. Plastic base
15. Weight base
16. Locking piece
17. Locking screw
18. Mosquito killer liquid
19. Timer display
20. Speed display
21. Mode display
22. Control buttons / Remote control
A. Mode
B. Timer
C. ON-OFF
D. Osc (Oscilation)
E. Speed
F. Mosquito repellent
USE AND CARE:
-
Fully extend the appliance's power cable be-
fore each use.
-
Do not use the appliance if its accessories
are not properly fitted.
-
Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
-
Do not use the appliance if the on/off switch
does not work.
-
Do not remove the support feet of the
appliance.
-
Do not move the appliance while in use.
MANUAL FA0008_Boreal No-moskit.indb 7
MANUAL FA0008_Boreal No-moskit.indb 7
-
Do not use the appliance if it is tipped up and
do not turn it over.
-
Do not turn the appliance over while it is in
use or connected to the mains.
-
Disconnect the appliance from the mains
when not in use and before undertaking any
cleaning task.
-
Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
-
Keep the appliance in a dry, dust-free place,
out of direct sunlight.
-
Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the applian-
ce.
-
Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the
appliance from operating correctly.
-
Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
-
Do not use the appliance to dry pets or ani-
mals.
-
Do not use the appliance to dry textiles of any
kind.
INSTALLATION
-
Be sure to remove all packaging material
from inside the appliance.
-
Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
-
Ensure that the appliance is level with res-
pect to the floor.
-
Do not cover or obstruct the sides of the
appliance and leave a minimum space of
40cm front other walls, ceiling.
-
The plug must be easily accessible so it can
be disconnected in an emergency.
-
The appliance should be used with its base
fitted.
ASSEMBLING THE BASE:
-
Fit the base with the column and secure it
with the screws provided (Fig.1).
-
To fix the base into the appliance, place the
appliance face down.
-
Stand the appliance up again so as to check
that the base works properly.
30/12/2022 13:39:06
30/12/2022 13:39:06
