Idiomas disponibles
Idiomas disponibles
4.
Maintenance
Some adjustments should be performed periodically to maintain the
machine in good working condition. Here is the maintenance
schedule:
ACTION
USE
Check the blade
attachment
Check the wire guide
attachment
Check the tire pressure
Check the blade
Clean the top and
bottom of the machine
Clean underneath the
guards
Clean the blade
attachment system
Clean the inside of the
wire guide
Clean the tires
Lubricate the blade
transmission shaft
Inspect and adjust the
belts
Inspect and tighten
bolts and nuts
4.1
Belt adjustment
The Perimeter Wire Machine 600MH-Li
belts. These should be inspected and/or adjusted twenty five (25)
hours of use. In some cases, they should be replaced. The main
reasons for replacing a worn belt are: cracking, loss of material,
unraveling, uneven wear or areas shiny due to heat or slippage.
NOTE: Do not overtighten the belts! The belt should move about
1cm when pressure is applied in the middle of the span.
4.1.1
Adjusting the engine belt
● Loosen the 8 bolts without
removing them (Figure
1,2);
● Using your hand, apply
pressure to the engine
mount until the belt is tight
(Figure 3);
● Tighten the 8 bolts.
2
3
BEFORE / EVERY
10
25
100
Storage
Hours
Hours
Hours
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
TM
is equipped with three (3)
4
4.1.2 Adjusting the blade transmission belt
1) Loosen the 6 bolts (see
Figure);
AFTER
2) Move the blade
Use
transmission to achieve the
desired tension;
3) Re-tighten the 6 bolts.
Maximum torque:
10 N-m (90 in-lb).
X
4.1.3
Adjusting the wheels transmission belt
X
1) Loosen the nut with a
13 mm wrench;
X
2) Pivot the transmission on its
axis to achieve the desired
X
tension;
X
3) Tighten the nut.
4.1.4 Lubricating the blade transmission shaft (10 hours)
Due to the vertical position of the
shaft, some grease is likely to
escape during normal use. A small
amount of grease should be
added to the transmission cap in
order to deliver additional grease
to the shaft. Follow instructions
included with the grease bottle
(PWMA-0009) supplied with your
PWM600MH-Li. One bottle will
last for about 10 refills.
Available as a spare part.
4.2
Storage
Always store the Perimeter Wire Machine 600MH-Li
4.3
Charger and battery (Sold separately).
4.3.1 Charger
4.3.1.1 Charging
If the battery has been stored with little charge or with no charge for
a long period, the charger enters restart mode which takes 20 hours
for the battery to be fully charged.
This prolongs the life of the battery. Once fully charged, standard
charging is available next time.
Any discharged battery requires a cooling period which is
mentioned in the battery user manual.
�
Plug the charger into the mains.
�
Insert the battery into the charger.
ONLY USE LUBRICANT PWMA-0009.
THE
BATTERY
IS
NOT
FULLY
RECOMMENDED TO CHARGE THE BATTERY FULLY
BEFORE THE FIRST USE TO ACHIEVE MAXIMUM
OPERATING TIME. THIS LITHIUM-ION BATTERY HAS NO
MEMORY
AND
CAN
BE
CHARGED
DISCRETION.
EN
TM
on its tires.
CHARGED.
IT
IS
AT
YOUR
7
