Idiomas disponibles
Idiomas disponibles
3.1.2.2 Spools with no defined shape
Some manufacturers provide wire designed to be wound around
the drum manually. As an optional accessory for the Perimeter Wire
Machine 600MH-Li
TM
, a PERIMETER WIRE DRUM (part
PWMA-0001) is available to allow the winding of the wire provided
by the manufacturer.
3.2
Moving the machine to the work zone
To move the machine to the work zone :
1) Loosen the clamping lever on the
handle;
2) Pivot the handle until it is vertical on
the machine.
3) Lift the support foot in front the
machine.
4) Pull or push the machine to the work
area.
3.3
Using the distance guide
The Perimeter Wire Machine 600MH-Li
adjustable distance guide. This is used to align the machine with
the edge of the course and bury the wire at a distance
between 15 cm and 45 cm. In addition, the distance guide can
be placed at the front or back of the machine, depending on
user preference.
BACK
FRONT
B
B
3.4
Self-propulsion
3.5
Inserting the perimeter wire in the wire guide
Proceed as follows:
1) Pull the end of the wire from the spool;
2) Insert the wire in the guide wire tube;
3) Push the wire until it emerges;
TM
is equipped with an
To use the distance guide:
B
1) Unscrew the wing nut
(See A);
2) Position the distance
guide
at
the
desired
distance according to the
ruler label (on the front or
B
back of the machine). The
ruler ensures positioning
between 15 and 45 cm to
the nearest centimeter.
(See B);
A
3) Tighten the wing nut.
The
Perimeter
Wire
Machine
TM
600MH-Li
is equipped with a
transmission for self-propulsion.
This allows for a constant rate of
installation
and
considerably
reduces operator effort.
3.6
Burying the perimeter wire in the ground
Refer to the manufacturer's instructions of the robot mower for the
technical specifications for installing perimeter wire.
Initially, attach the end of the wire to a stake or a tool planted in the
ground.
1)
Start the motor;
2)
Lift the support foot at the front of the machine;
3)
Slowly insert the blade into the ground by pressing down on
the handle until the frame is parallel to the ground (Figure 1);
4)
Apply pressure to the traction handle to move the machine
(Figure 2).
1
1
3.7
Adjusting the handle height
It is important to adjust the
handle height before working
with
the
Perimeter
Wire
TM
Machine
.
3.8
Overcoming obstacles in the ground
When burying the wire in the ground, some immovable obstacles
such as large rocks or roots will be encountered. To avoid damage
to the blade and/or the machine, follow the instructions below :
EN
2
The
recommended
handle
position is at the waist level, but
adjust it to your preferred height
using the handle clamping lever.
5
