Idiomas disponibles
Idiomas disponibles
2.2.5
Starting the motor
The controls can be found on the motor's housing, above the
battery cavity.
Operating the unit: Press twice to turn on and press
A)
again to turn off.
B)
Press to select the speed of the motor.
Once = slow
Twice = medium
Three times = fast
Note : A higher speed reduces the battery's operating time.
1 A
THE LITHIUM-ION BATTERY IS FITTED WITH AN INTERNAL
BREAKER
MACHINE IN CASE OF OVERLOAD. IF THIS HAPPENS,
TURN THE DEVICE OFF BY PRESSING BUTTON ''A'' (SEE
ILLUSTRATION).
3.
Usage
ITS COMPACT SIZE AND LIGHT WEIGHT MEAN THE
PERIMETER WIRE MACHINE 600MH-LI
TRANSPORTED IN A SMALL VEHICLE. REMOVING THE
BATTERY IS HIGHLY RECOMMENDED WHEN DOING
THIS.
Before each use :
● Check the soil consistency and the deepest possible insertion depth.
● Check the blade attachment.
● Check the attachment of the wire guide.
● Check the tire pressure.
3.1
Installing the perimeter wire spool
The Perimeter Wire Machine 600MH-Li
accommodate most wire spools provided by the manufacturers and
third party resellers of robot lawnmowers.
IMPORTANT:
Six
stepped
accommodating
spools
diameters. Select the spacers that will allow for easy insertion
of the rod and spool assembly with the most direct path to the
wire guide located behind the blade.
3.1.1
Spools mounted on a drum
The hardware provided is suitable for installation of most models up
to 800 meters (depending on the wire's diameter):
1 1
1 B
WHICH
AUTOMATICALLY
STOPS
TM
CAN BE EASILY
TM
is designed to
spacers
are
supplied
of
different
width
and
1) Unscrew the clamping handle and
remove with the flat washer.
2
3
3) Remove the shaft (with the hardware). Then remove the hardware.
4
NOTE: Make sure the wire is dispensed from the top of the reel.
a. Spacer(s);
b. The left centering hub (towards the inside of the spool);
c. The spool (support at the right level depending on its diameter)
THE
on the hub;
d. The right centering hub (towards the inside of the spool);
e. Spacer(s);
f. The rubber washer;
5
for
center
NOTE: When the adequate reel tension is set, you can tighten the handle's
jam bolt slightly to keep it in position. Do not overtighten to prevent
damaging the threads on the rod.
3.1.2
Spools without a drum
3.1.2.1 Spools that empty through the center
Some manufacturers supply a spool designed to be emptied
through the center. Two (2) PERIMETER WIRE BOXES 18 cm x 18
cm (part PWMA-0002) and 22.5 cm x 22.5 cm (part PWMA-
0003), available as optional accessories for the Perimeter Wire
Machine 600MH-Li
21 cm in diameter, depending on the box used).
2) Lift the shaft while opening the
blocker.
4) Insert in the desired order
depending on the spool used.
NOTE: The spool holding arm may
need to be adjusted to fit the spool and
to avoid unnecessary turning of the
handle when setting the reel tension.
5) Insert the shaft by sliding it into the
slots provided (arch and adjustable
spool support). Return the flat washer
and the clamping handle to the shaft.
Turn the clamping handle until there is
sufficient tension to prevent the spool
from free wheeling.
TM
, accepting this type of spool (up to 17.5 cm or
EN
4
