Idiomas disponibles
Idiomas disponibles
Some pans make
crackling or clicking
noises.
The induction hob
makes a low humming
noise when used on
a high heat setting.
Fan noise coming from
the induction hob.
Pans do not become
hot and appears in the
display.
The induction hob or a
cooking zone has
turned itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two digits
in the cooking timer
display).
8. Failure Display and Inspection
The induction hob is equipped with a self diagnostic function. With this test the technician is able to
check the function of several components without disassembling or dismounting the hob from the
working surface.
Troubleshooting
1) Failure code occur during customer using & Solution;
Failure code
Ceramic plate temperature sensor
E1
failure--open circuit.
Ceramic plate temperature sensor
E2
failure- -short circuit.
Eb
Ceramic plate temperature sensor failure
High temperature of ceramic plate
E3
sensor.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
This is caused by the technology
of induction cooking.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue to
run even after you've turned the
induction hob off.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot detect
the pan because it is too small
for the cooking zone or not
properly centred on it.
Technical fault.
Problem
No Auto-Recovery
This is normal for cookware and
does not indicate a fault.
This is normal, but the noise should
quieten down or disappear completely
when you decrease the heat setting.
This is normal and needs no action. Do
not switch the power to the induction
hob off at the wall while the fan is
running.
Use cookware suitable for induction
cooking. See section 'Choosing the
right cookware'.
Centre the pan and make sure that its
base matches the size of the cooking
zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
Check the connection or replace the
ceramic plate temperature sensor.
Wait for the temperature of ceramic
plate return to normal.
21
Solution
