Idiomas disponibles
Idiomas disponibles
The device will perform the functions, e .g . calibration of
y
sensors .
Depending on the device function, media will come out of
y
the paper output tray with or without print function .
7.6.1
Check the Configuration Data of the Device
If a self-test has been performed or settings have been
changed: The device's configuration data will be printed . The
printout contains the following information:
Configuration data
YDP30 | YDP30-NET Version: X .XX . XX
SERIAL NO .:
MILAGE (m): XXX
CHECKSUM: XXXXXXXX
SERIAL PORT: XXXX, X , X , X
CODE PAGE: XXX
COUNTRY CODE: XXX
SPEED: X INCH
DENSITY: X . X
SIZE: X .XX , X .XX
GAP: X .XX , X .XX
TRANSPARENCE: X
[FILE LIST:]
[Sample]
Procedure
Check the information on the printout .
t
If required: Change the settings .
t
7.6.2
Checking Core Dump
In the core dump, characters are listed in two columns . The
received characters are listed in the left column . The hexadeci-
mal values of the characters are listed in the right column .
Procedure
Check the information on the printout .
t
If required: Change the settings .
t
7.7
Re-starting the System
Procedure
Commission the device (see Chapter "5 Getting Started",
t
page 10) .
Description
Name and firmware version on the main board
No entry
Already printed (in meters)
Checksum of the main board firmware
Configuration of the "RS232" connection
Code page
Country code
Print speed in inch/second
Print density
Label size: Width, height
Gap size (vertical gap, offset)
Sensor sensitivity
File management information, e .g . number of files in the internal memory
Print head test sample
Cleaning and Maintenance
Operating Instructions YDP30 | YDP30-NET
19
