Removing Media From Media Mounts; Cleaning The Sensors And Interior Components; Cleaning The Print Head; Cleaning The Print Roller Or Tear Bar - Sartorius YDP30 Instrucciones De Manejo

7.4

Removing Media from Media Mounts

Procedure
Switch off the device .
t
Open the top cover .
t
If release paper of self-adhesive media has been inserted:
t
Open the front cover .
t
Pull the release paper out of the release paper opening .
t
Close the front cover .
t
Push the 2 mounts of the media feed apart and remove the
t
media spool .
7.5 Cleaning the Sensors and Interior
Components
7.5.1

Cleaning the Print Head

The print head must not be touched . The print head must be
cleaned with 100% ethanol and a cotton swab or with a print
head cleaning pen .
The print head must not come into contact with medical
alcohol . Medical alcohol can damage the print head .
Requirements
An ink ribbon has not been inserted into the device .
Procedure
Switch off the device .
t
Open the top cover .
t
Open the ink ribbon cover .
t
1
If the print head accidentally comes into contact with skin:
t
Clean the print head again .
Use a cotton swab moist-
t
ened with 100% ethanol or
a print head cleaning pen
to clean the print head (1) .
7.5.2

Cleaning the Print Roller or Tear Bar

The print roller and tear bar must be cleaned with 100%
ethanol and a cotton swab or lint-free cloth .
Requirements
There are no media in the device .
Procedure
Switch off the device .
t
Open the top cover .
t
Moisten a cotton swab or lint-free cloth with 100% ethanol .
t
1
2
7.5.3

Cleaning Sensors or the Interior

The sensors and the interior of the device must be cleaned with
an air brush or a vacuum brush .
Requirements
There are no media in the device .
Procedure
Switch off the device .
t
Open the top cover .
t
1
2
3
Clean the interior components with an air brush or a
t
vacuum brush .
Operating Instructions YDP30 | YDP30-NET
Cleaning and Maintenance
Wipe the print roller (1) .
t
Turn the print roller so that
the entire surface of the
print roller can be cleaned .
Wipe the tear bar (2) .
t
Clean the distance sensor
t
(receiver) (1), distance
sensor (transmitter) (2), and
sensor for black marking (3)
with an air brush or a
vacuum brush .
17