Husqvarna RC 318T Manual De Usuario página 21

Maintenance
Do an inspection of and adjust the front and rear wheel rotation speed (for AWD
models only).
Replace the transmission filter (for AWD models only).
Replace the spin on filter for the servo (if applicable).
Do a check of the cooling fan on the hydrostatic transmission.
Do a check of the oil in the transmission and fill if it is necessary. Refer to
a check of the transmission oil level on page 32 .
Replace the oil in the transmission.
Examine and adjust the parking brake.
Clean the outer and inner surfaces of the cutting deck and the cutting deck
To clean the product on page 21 .
covers. Refer to
Do a check of and adjust the cutting height and pitch setting. Refer to
check of and adjust the cutting deck ground pressure on page 28 and To do a
check of the parallelism of the cutting deck on page 29 .
Examine the blades in the cutting deck, sharp and balance if necessary. Refer to
To examine the blades on page 30 and To examine the blades on page 30 .
Do a check of and adjust the engine RPM.
Make sure that the product does not move in neutral position. Refer to
check of the forward pedal and rearward pedal on page 10 .
Do a check of the forward drive and the rearward drive on different speeds.
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Safety devices on the product on page 9 .
Do an inspection of the collection system (for collection models only).
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which cause damage to the
product.
Clean the product directly after use.
• Before you stop the engine, let the auger run empty
for 10 seconds to clear it from remaining grass.
• Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
• Before you clean with water, use a brush to remove
grass cuttings and dirt from on and around the
transmission, the transmission air intake, and the
engine.
• Use running water to clean the product. Do not use a
high pressure.
368 - 006 - 10.11.2022
Do not use a high pressure
First
servicing
To do
To do a
To do a
• Do not point the jet at electrical components or
bearings. Cleaning additives usually increase the
damage.
• To clean the cutting deck, put it in the servicing
position and hose it down with water.
• Hose down the inner surface of the collector with
water.
• Clean the auger in- and outlets.
• When the product is clean, start the product for a
short period to blow off remaining water.
Maintenance interval
in hours
50 100 200
O O
O
O
O O
X
O
O O
X X
X X
X
O O
X X
O O
X X
X X
O
O
O
21