Husqvarna RC 318T Manual De Usuario página 18

9. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts and the blades stop
to rotate.
10. To empty the collector, press the rear part of the
switch used to tilt the collector. The collector lifts.
Hold the switch pressed until the hatch opens and
the grass falls out.
B
A
11. Press the front part of the switch to lower the
collector to operating position.
Note:
If the collector is fully tilted or lowered and you
continue to press the switch, a clattering sound is heard.
This shows that the collector is at the end positions.
WARNING:
between the collector and the frame. Do not
put your hand on the frame or the collector
when the collector is lowered.
To use the product in non-collect mode
1. Start the engine.
18
Fingers can get crushed
2. Make sure that the symbol on the auger control
button is blue. This shows that the product is in non-
Auger control switch with LED
collect mode. See
indicators on page 5 for information on what to do if
the symbols on the auger control switch lights up or
the auger control button is red.
To use the product in collect mode
3. Do steps 4–8 in
on page 17 .
4. When you start to mow, the grass is not collected.
To stop the engine
1. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck. The blades
stop to rotate.
2. Turn the ignition key to the STOP position.
3. When the product stops, apply the parking brake.
To apply and release the parking brake
1. Press the parking brake pedal down (1).
368 - 006 - 10.11.2022