Husqvarna RC 318T Manual De Usuario página 13

To attach the cutting deck
1. Place the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
4. Set the lift lever for the cutting deck in mowing
position.
5. Lower the auger servicing position lever to lift the
auger to servicing position.
6. Put the drive belt as illustrated to make sure that
it does not get pinched when the cutting deck is
attached.
7. Push the equipment frame down. Lift the service lock
to vertical position.
368 - 006 - 10.11.2022
WARNING:
mechanism can cause injury to
fingers if you do not operate it
carefully. Put the service lock in full
vertical position and hold the front
edge of the cutting deck with two
hands when you continue to the
next step.
8. Lift the front edge of the cutting deck and move it
into the equipment frame. The plugs on the cutting
deck, one on each side, must be put in the grooves
on the equipment frame. The service lock releases
automatically.
9. Lift the cutting height stay from the stay holder and
put it in the hole for the cutting height stay (1).
10. Put the drive belt around the tension wheel (2). Make
sure the drive belt runs as illustrated below.
11. Put the spring in the spring holder (3).
The lock
1
2
3
13