Idiomas disponibles
Idiomas disponibles
EN
PT
4. Move the choke lever to the
closed position.
(1) Choke lever (2) Close (3) Open
5.Set the stop switch to the (1)
position. Set the throttle trigger to
the start position (1 -> 2 -> 3).
Place the unit on a flat, firm place.
Keep the cutting head clear of
everything around it.
(1) Stop switch
6. While holding the unit firmly, pull
out the starter rope quickly until
engine fires.
50
IMPORTANT
Avoid pulling the rope to its end or
release it freely. Such actions may
cause damage.
7. Move the choke lever downward to
open the choke. Pull out the cord until
the engine starts.
(1) Choke lever (2) Close (3) Open
8. Allow the engine to warm up for
a several minutes before starting
operation.
NOTE: 1. When restarting the
engine immediately after stopping
it, leave the choke open.
When the engine failed to start after
several attempts, open the choke
and repeat pulling the rope, or
remove the spark plug and dry it.
STOPPING ENGINE
1. Release the throttle lever and run
the engine for half a minute.
2. Shift the stop switch to the STOP
position.
IMPORTANT
Except for an emergency, avoid
stopping the engine while pulling
the throttle lever.
ADJUSTING
THROTTLE CABLE
Readjust with the cable adjuster as
required.
Cable adjuster
ADJUSTING
IDLING SPEED
Idle adjusting screw
1. When the engine tends to stop
frequently at idling mode, turn the
adjusting screw clockwise.
2. When the cutting head keeps
rotating after releasing the trigger,
turn the adjusting screw counter-
clockwise.
NOTE: Warm up the engine before
adjusting the idling speed.
WARNING
The cutting head will start rotating
upon the engine starts.
CUTTING WORK
(LINE HEAD USAGE)
WARNING
1. Always wear eye protection such
as safety goggles. Never lean over
the rotating cutting head. Rocks or
other debris could be thrown into
eyes and face and cause serious
personal injury.
2. Keep the cutting attachment
guard in place at all times when the
unit is operated.
