Idiomas disponibles
Idiomas disponibles
EN
1. Grip the handles firmly with both
hands using your whole hand. Place
your feet slightly apart (slightly
further apart than the width of your
shoulders) so that your weight is
distributed evenly across both legs,
and always be sure to maintain a
steady, even posture while working.
2. Keep cutting attachment below
waist level.
3. Maintain the speed of the engine at
the level required to perform cutting
work, and never raise the speed of
the engine above the level necessary.
4. If the unit starts to shake or vi-
brate, turn off the engine and check
the whole unit. Do not use it until the
trouble has been prop-erly corrected.
5. Keep all parts of your body away
from rotating cutting attachment
and hot surfaces.
6. Never touch the muffler, spark
plug, or other metallic parts of
the engine while the engine is in
operation or immediately after
shutting down the engine. Doing
so could result in serious burns or
electrical shock.
44
7. Never operate the pruner at an
angle greater than 60 in order to
reduce the risk of being struck by
falling objects during operation.
WARNING
Approaching or contacting
electric power lines with pruning
saw may cause serious injury or
death from eletrocution.
Electricity can jump from one
point to another by means of
arcing or may be conducted
through damp branches.
Maintain a clearance of at
least 15m between Pole saw
and any electrical line carrying
live current.
IF SOMEONE COMES
1. Guard against hazardous situa-
tions at all times. Warn adults to
keep pets and children away from
the area. Be careful if you are
approached. Injury may result from
flying debris.
2. If someone calls out or otherwise
interrupts you while working, al-
ways be sure to turn off the en-gine
before turning around.
MAINTENANCE
1. In order to maintain your product
in proper working order, perform
the maintenance and checking
operations described in the manual
at regular intervals.
2. Always be sure to turn off the en-gine
and disconnect the spark plug wire
before performing any maintenance
WARNING
The metallic parts reach high
tem-peratures immediately after
stopping the engine.
3. When replacing the cutting at-
tachment or any other part, or when
replacing the oil or any lu-bricant,
always be sure to use only authorized
products or products which have
been certified by your supplier
4. In the event that any part must
be replaced or any maintenance or
repair work not described in this
manual must be performed, please
contact a representative from the
store nearest ITOOLS authorized
servicing dealer for assistance.
5. Do not use any accessory or
at-tachment other than those
bear-ing the ITOOLS mark and rec-
ommended for the unit.
6. Under no circumstances should you
ever take apart the product or alter it in
any way. Doing so might result in the
product be-coming damaged during
opera-tion or the product becoming
unable to operate properly.
HANDLING FUEL
1. The engine of our 4 in 1 product
is designed to run on a mixed fuel,
which contains highly flam-mable
gasoline. Never store cans of fuel
or refill the tank of the unit in any
place where there is a boiler, stove,
wood fire, electrical sparks, welding
sparks, or any other source of heat
or fire which might ignite the fuel.
