Scheppach SG7100 Traducción Del Manual De Instrucciones Original página 25

Your machine is not fully assembled
Assembling the transport device (Fig. 4/5/6)
1. Guide the wheel axle (I) through the guide (a) until
it latches.
2. Guide the wheel (13) onto the wheel axle (I) and
fasten to the wheel axle with a washer (P) and
spring washer (O) and one hexagonal nut (K) re-
spectively. (Fig. 4)
3. Mount the support foot (B) on the frame strut at the
bottom. Fasten the support foot with two screws
(G) and nuts (M) (Fig. 5)
4. Mount the transport handles (7) on the frame. Fasten
the transport handles with the screw (H) and nut (M);
two plastic washers respectively are placed between
the frame and fork of the transport handle. (Fig. 6)
Attention! Fill the oil before first use.
Before each use, check the oil level with the engine
switched off and on a level surface. Use the highest quali-
ty four-stroke oil or an HD oil with the same level of quality.
Checking the oil level (Fig. 7)
Remove the oil filler cap (12) and wipe the dipstick
clean. Check the oil level by inserting the dipstick into
the filling nozzle without screwing the cap on. If the oil
level is too low, refill with the recommended oil up to the
lower rim of the oil filling nozzle.
Oil warning system
The oil warning system is configured to avoid dam-
age to the engine due to a lack of oil in the spherical
housing. Before the oil level in the spherical housing
can drop below the safety level, the oil warning system
automatically cuts the engine off (the ignition switch re-
mains in the ON position). If the oil warning system cuts
the engine off, refill the engine oil.
Refuelling
Warning! Petrol is highly inflammable and explo-
sive. When handling fuels, you may suffer burns or
other severe injuries.
Use petrol with an octane rating of at least 90 octane.
Only use fresh, clean fuel. Water or impurities in the
petrol damage the fuel system.
Tank volume: 25 litres
• Only fill the tank up to the marking in the fuel strainer.
• Note that fuel expands.
• Refuel in a well-ventilated area with the engine
stopped. If the engine was in operation immediately
before, allow it to cool first.
• Never refuel the engine in a building where the petrol
vapour may come into contact with flames or sparks.
• Do not smoke whilst refuelling or in the area in which
the petrol is stored and prevent naked flames or
sparks under these circumstances.
• After refuelling, ensure that the tank cover is closed
correctly and securely again. Take care!
• Mop up spilled petrol immediately.
• If petrol is spilled, ensure that the area is dried be-
fore starting the engine.
• Avoid repeated or long contact of the fuel with the
skin and avoid breathing in the fumes.
• Keep the fuel out of the reach of children.
• If there are occasional taps or knocks from the en-
gine, you should use a different brand of petrol.
• If this does not solve the problem, contact an au-
thorised dealer.
Connecting the battery
Now connect the red cable to the plus pole (+) and the
black cable to the minus pole (-).
Note: The battery charges itself during operation.
WARNING: Operating the engine with continuous
ignition tapping or knocking can result in damage
to the engine. Operating the engine with continu-
ous ignition tapping or knocking is considered im-
proper use. The manufacturer is not responsible
for the resulting damages; the user solely bears
the risk.
9. Start up
Earthing the generator
The power unit is equipped with an earth that connects
the frame structure of the unit to the earth connections
in the a.c. sockets. The earth is not connected to the
a.c. neutral cables. If the power unit is tested with a
phasing tester, it does not have the same ground loop
as a normal household appliance. To protect against
electric shock, ensure that the generator is earthed.
Connect the generator and the external earth source,
e.g. a water pipe that is driven into the earth or a copper
pipe that is driven into the earth, with a thick wire.
WARNING: Do not use any pipes that carry inflam-
mable substances as an earth source.
Start the engine (Fig. 1 + 2)
NOTE: Do not connect the electrical device before
starting the engine.
Turn the fuel valve (18) to ON.
www.scheppach.com GB | 25