Dometic POWER & CONTROL BS12-100 Guía Rápida página 4

Ocultar thumbs Ver también para POWER & CONTROL BS12-100:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
NOTICE! Damage hazard
Check that the voltage specification on the data plate corresponds to that of the energy sup-
ply.
Never immerse the device in water.
Protect the device and cables against heat and moisture.
Do not expose the device to rain.
5
Intended use
The device is used for automatic monitoring of the state of charge of a house battery, to prevent deep discharge.
The device is primarily used in (but not limited to) caravans and motor homes.
The device disconnects the battery automatically if the voltage drops down under the minimum voltage limit of
11 V. The battery can also be manually disconnected with an on/off button.
The device is not intended to be used as starting battery switch, but only for house batteries where the maximum
currents (charge and discharge) are below the value of 100 A (continuous).
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor
installation and/or improper operating or maintenance will result in unsatisfactory performance and a possible
failure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
Incorrect assembly or connection, including excess voltage
Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
Alterations to the product without express permission from the manufacturer
Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and product specifications.
6
Disposal
Recycling products with non-replaceable batteries, rechargeable batteries or light sources:
If the product contains any non-replaceable batteries, rechargeable batteries or light sources,
you don't have to remove them before disposal.
If you wish to finally dispose of the product, ask your local recycling center or specialist dealer
for details about how to do this in accordance with the applicable disposal regulations.
The product can be disposed free of charge.
Recycling packaging material: Place the packaging material in the appropriate recycling waste bins
wherever possible.
4
loading

Este manual también es adecuado para:

Power & control bs24-100Bs12-100Bs24-100