Safety; Identification Of Warnings; General Points; Transport/Disposal - SFA Smart Control Box Manual De Instalación

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35

1. SAFETY

1.1 IDENTIFICATION OF WARNINGS

Meaning
This term defines a high risk of danger, which can
DANGER
lead to death or serious injury, if not avoided.
This term defines a medium risk of danger, which can
WARNING
lead to serious or minor injury, if not avoided.
This term characterises dangers to the machine and
NOTICE
its proper operation.
Warning of a general danger.
The danger is specified by indications given in the
table.
This symbol characterises dangers associated with
the voltage and provides information on voltage
protection.

1.2 GENERAL POINTS

This operating and installation manual contains important instructions
to follow for the fitting, operation and maintenance of the XXX control
box. Following these instructions guarantees safe operation and pre-
vents injury and property damage. It always has to be available on site
of operation of the machine/plant.
Not only the general safety instructions mentioned in this main point
on safety have to be observed, but also the special safety instructions
mentioned in the other sections.
Failure to comply with this operating and installation manual will result
in the loss of warranty rights and rights to damages.

2. TRANSPORT/DISPOSAL

2.1 TRANSPORT

For all transportation, the control panel must be switched off (see 7.
Shutdown)
ENVIRONMENTAL TRANSPORT CONDITIONS:
Parameters
Relative humidity
Ambient temperature

2.2 DISPOSAL

The device must not be disposed of as household waste
and must be disposed of at a recycling point for electrical
equipment. The device's materials and components are re-
usable. The disposal of electrical and electronic waste, re-
cycling and recovery of any form of used appliances con-
tribute to the preservarion of our environment.

3. DESCRIPTION

3.1 APPLICATION

The Smart control box is a monitoring and control box for SFA lifting
stations. It allows the operation and parameterization of the connected
station, as well as the real time consultation of the activity and opera-
tion history.

3.2 TECHNICAL DATA OF THE CONTROL BOX

Parameter
Nominal supply voltage
Network frequency
Protection class
Type
Power cable
Length

3.3 TECHNICAL DATA OF THE DETECTION DEVICE

• Analog level sensor
• Signal 0-5 V
• Input voltage 0-12 V
Value
85% maxi. (no condensation)
-10°C to+70°C
Value
1 ~ 220-240 V AC
50-60 Hz
IP 54
1~ version: H07RN-F-3G 1.5 mm
3~ version: H07RN-F-5G 2.5 mm
2.5 m

3.4 DIMENSIONS

Sanicubic
Sanifos

4. INSTALLATION

DANGER
Submersion of the control device.
Risk of electric shock!
 Only use the control device in rooms safe from floods.

4.1 WALL MOUNTING

The Smart controm box must be installed indoors, in a place protected
from humidity and frost.
The Smart control box is supplied with a wall bracket.
• Mount the wall bracket horizontally, using the appropriate fixings for
your wall.
• Snap the Smart control box onto the bracket.
4.2 CONNECTION OF THE FLOAT (SANIFOS) AND PUMP
CABLES
Cables are connected via waterproof terminal blocks.

4.2.1 Preparation of the conductive wires

Conductor
Disassembly length y (mm)
Stripping length x (mm)
2
2

4.2.2 Connectors wiring for pumps (Sanipump)

NOTICE
 It is imperative to respect the colours of the wires
when making the connections so as not to cause a mal-
function.
17
EN
Connector
PE
1~: N, L
3~: L1, L2, L3
33
25
8
8
Tabla de contenido
loading

Tabla de contenido