ResMed TxLink 2 Guia Del Usuario página 5

Setup
Using the cables supplied, connect the TxLink 2 as shown.
1
TxLink 2 PAP device cable (power/communications)
2 Power supply unit
3, 4
Ethernet cable
For further assistance, contact your ResMed representative or refer to the Titration Equipment Installation
Guide in ResMed.com/downloads/titrationsolutions.
Turning off the TxLink 2
To turn off the TxLink 2, place the connected therapy device in standby and disconnect the power cable
from the power outlet or turn off the switch at the power outlet.
Turning off the TxLink 2 will also turn off the therapy device that is connected via the TxLink 2 PAP device
cable (power/communications). For running the therapy device without the TxLink 2, plug the appropriate
power supply unit directly into the therapy device.
CAUTION
The USB Type B port is only to be connected to a computer during installation and setup of
TxLink 2, not while the patient is connected to the therapy device.
4
Bedroom Control room