Safety Instructions For All Operations - Safety Warnings Common For Sanding - Parkside PWDS 920 B2 Instrucciones De Utilización Y De Seguridad

6) Keep cutting tools sharp and
clean. Properly maintained cutting tools
with sharp cutting edges are less likely to
bind and are easier to control .
7) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation .
Service
Have your power tool serviced by
1)
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained .
˜ Safety instructions for all
operations ‒ Safety warnings
common for sanding
1)
This power tool is intended to
function as a sander. Read all safety
warnings, instructions, illustrations
and specifications provided with
this power tool. Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury .
2) Operations such as grinding, wire
brushing, polishing or cutting-off are
not recommended to be performed
with this power tool. Operations for
which the power tool was not designed may
create a hazard and cause personal injury .
78 GB/MT
3) Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation .
4) The rated speed of the accessory
must be at least equal to the
maximum speed marked on the
power tool. Accessories running faster
than their rated speed can break and fly
apart .
5) The outside diameter and the
thickness of your accessory must be
within the capacity rating of your
power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled .
6) Threaded mounting of accessories
must match the grinder spindle
thread. For accessories mounted
by flanges, the arbour hole of the
accessory must fit the locating
diameter of the flange. Accessories
that do not match the mounting hardware
of the power tool will run out of balance,
vibrate excessively and may cause loss of
control .