Air Filter - MAAX Grondfress 21039 Manual De Usuario

IF YOUR TINES GET JAMMED OR ENTANGLED, SHUT OFF THE ENGINE AT ONCE .
REMOVE THE ORSTRUCTION WHILE THE ENGINE IS OFF NEVER TRY TO REMOVE AN OBSTRUCTION
MAINTENANCE
How to check. Clean and change the air filter. Check the air filter every 25 hours of use or more
frequently if used under dusty conditions. A clogged air filter may increase fuel consumption while
cutting down the engine filter or with a deformed filter element because unfiltered dusty air will
quickly ruin the engine.
Cleaning air filter
1. Remove the air cleaner cover by pulling the tab on side and take out the 3 filter element.
2. Using neutral detergent and warm water to clean the filter elements. After cleaning,
air dry the element completely and moisten with a small amount of motor oil.
3. Please the filter element into the air cleaner housing and press the cover against the
housing until it clicks.
Idle Speed Adjustment
1. Warm up engine before adjust idle speed.
2. The idle speed adjustment screw controls the throttle opening at idle position.
3. When the engine tends to stop frequently at idling mode. Turn the adjusting screw clock wise.
4. If the tines continues to rotate after releasing the trigger, turn the adjusting screw
counter-clockwise.
y before
GLED,
NGINE
CTION
NJURY

air Filter

use or Clear Blockages From the fuel line & filter
Clear Blockages From the fuel line & filter
After you've used your tiller /cultivator for a few seasons, check for blockages in the fuel tank and
nditions. After you've used your tiller /cultivator for a
fuel filter. Such blockages can keep your tiller / cultivator from starting.
se fuel few seasons, check for blockages in the fuel
Clear any blockages you see in the tank, fuel filter, or fuel line.
Remember: The fuel filter is located inside the tank. Then use normal starting procedure to start your
engine tank and fuel filter. Such blockages can keep
tiller / cultivato.
because your tiller / cultivator from starting.
Spark Plug
engine . Clear any blockages you see in the tank, fuel
1. Starting failure and mis-firing are often caused by a fouled spark plug.Clean the spark plug and
check the that the plug gap is in the correct range. ( 0.6 ~0.7mm)
filter , or fuel line .
2. CAUTION: Do not over tighten the spark plug. To install the spark plug first turn the plug until it is
Remember: The fuel filter is located inside
lling the
finger tight, then tighten it a quarter turn more with a socket wrench.
lement.
the tank . Then use normal starting procedure
water to to start your tiller / cultivato
ning , air Spark Plug:
moisten 1. Starting failure and mis-firing are often
▲ WARNING ▲ DANGER ▲
WHILE THE ENGINE IS RUNNING. SERIOUS INJURY CAN RESULT.
63