Maintenance Schedule; Maintenance - Husqvarna LG 504 Manual De Usuario

Ocultar thumbs Ver también para LG 504:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CAUTION:
product when the LED indicator (D) is
on with a constant red light. This causes
wear to the product.
E: Red or green. Power supply indicator.
When you turn the ignition key, a calibration of the
compaction indicator starts. All LED indicators (A) to
(E) come on. After approximately 4 seconds, the LED
indicator (E) changes from red to green and the LED
indicators (A) to (D) go off. When the LED indicators (A)
to (D) are off and the LED indicator (E) is green, you can
start the product.
To operate the product
Always operate the product with the throttle control set
to full throttle.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Examine the throttle control and the forward and reverse
control for damage.
Make sure that the forward and reverse control can
move smoothly.
Lubricate the forward and reverse control and the link-
ages of the controls.
Examine the safety straps for damage. Replace if it is
necessary.
Examine the vibration damping units for damage.
Examine the tension of the V-belt and look for damages.
Adjust or replace the V-belt as necessary.
12
Do not operate the

Maintenance

Read and understand the
To operate the product forward, move the operation
control fully forward and release it.
To operate the product rearward, move the operation
control fully rearward and release it.
To stop the movement of the product, move the
operation control in the opposite direction in small
movements until the product is stationary.
To change direction, turn the product around by the
handle.
X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
Before use,
Each 100 h
each 10 h
*
X
*
*
*
*
*
X
X
Each 6
Yearly, each
months or
500 h
250 h
X
X
X
X
1229 - 004 - 12.10.2022
Tabla de contenido
loading

Tabla de contenido