Assembling; B-510Bf/Ergo/Ph/Asb - Optika B-510 Serie Manual De Instrucciones

8.

Assembling

8.1

B-510BF/ERGO/PH/ASB

1. Insert the optical head above the stand and tighten the screw.
(Fig. 1)
• Hold the head with one hand during the locking in order
to avoid that the head falls.
2. Insert both eyepieces into the tubes of the optical head. (Fig.
2)
3. Condenser is pre-installed in the factory. To remove the
condenser use an Allen wrench 1,5 mm diam and operate on
the locking screw placed on the right side of the condenser
holder.
4. Screw each objective into the thread of the nosepiece,
clockwise with increasing magnification. (Fig. 3)
5. Insert the power supply jack in the connector placed at the
rear side of the microscope. (Fig. 4)
Page 23
F ig. 1 F ig. 1
F ig. 2 F ig. 2
F F ig. 3 ig. 3
F ig. 4 F ig. 4