Types Of Work - Hilti TE 700-AVR Manual De Instrucciones

5.6 Locking the chisel
▶ Set the function selector switch to
engages.
5.7 Setting the chiseling power
Chiseling power can be reduced to approx. 70% by pressing the power
level selector switch. The power level LED then lights up, indicating
reduced power.
Chiseling power can be adjusted only when the power tool is switched
on and ready for use. To reselect full chiseling power, press the chiseling
power level selector switch again. Switching off and then on again also
causes the power tool to return to full chiseling power.
▶ Press the power level selector switch.
6

Types of work

WARNING
Risk of electric shock! Severe injury and burns can result if any attempt
is made to operate the tool without an earth/ground conductor and ground
fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used, always
make sure that an earth/ground conductor and ground fault circuit
interrupter are present in the power supply and that these are correctly
connected.
▶ Do not use the product unless these safety measures are in place and
fully operational.
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord
or extension cord if damaged while working. Disconnect the supply cord
plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it
replaced by a qualified specialist if found to be damaged.
Full approval must be obtained from the site engineer or architect prior to
beginning the work.
6.1 Chiseling 6
▶ Set the function selector switch to the
10 English
and rotate the chisel until it
position.
428076
*428076*