Minimum Power Heating Mode; Maximum Power Heating Mode; Eco Mode (Temperature Setting) - Olimpia splendid CALDO UP T WIFI Instruccioes Para La Instalación, Uso Y Mantenimiento

9.2 - Minimum power heating mode

When the appliance is switched on in fan mode, press button
imum power heating. In addition to the FAN LED, the LOW LED also switches on on
the appliance display.

9.3 - Maximum power heating mode

When the appliance is switched on in minimum power mode, press button
activate the maximum power heating. In addition to the FAN LED, the HIGH LED also
switches on the appliance display (and the LOW LED switches off).
It is also possible to activate this mode through the START/STOP
button on the back of the appliance (pos. 12 - figure X).
Press button START/STOP again and the unit switches to STAND-
BY mode (and switching off occurs as described in the next para-
graph).
If one of the heating modes has been activated, press the ON/OFF
button to turn the appliance off, the FAN LED starts flashing
and the display starts the 30 seconds countdown after which the
appliance turns off (as well as the FAN LED).

9.4 - ECO mode (temperature setting)

Ambient temperature is shown on the display when the appliance is turned on.
When the appliance is on, pressing button
flash and the set temperature value to be shown.
Within 5 seconds, press buttons
18°C÷45°C - 1°C variations). To confirm the setting, please wait 5 seconds; the display
goes back to show ambient temperature.
If the set temperature is slightly higher than the ambient one (+1÷2°C), the minimum
power heating function activates automatically (FAN and LOW LEDs turned on).
If the set temperature is greatly higher than the ambient one (>3°C), the maximum pow-
er heating function activates automatically (FAN and HIGH LEDs turned on).
If the set temperature is lower than ambient temperature, the appliance ends heating
function, after 30 seconds the fan stops (LOW and HIGH LEDs flashing) and flap oscil-
lation stops (LED flashing).
The set temperature can be changed at any moment during functioning.
EN - 18
will cause the temperature value to
and to set the desired temperature (range:
to activate the min-
to