Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.2.h - Wifi function
Press the key "Speed" (D5) for approximately 5 seconds to activate the "Wifi" function; the LED (L6)
starts to blink.
When the appliance connects with your smartphone, the LED (L6) stops blinking and re-
mains switched on steadily on the display.
The instructions for connection to the WiFi network and for use oft he App are available on
www.olimpiasplendid.com in the download area.
3.2.i - Oscillation function
Press the "mode" key (D2) for approximately 3 seconds, the flap (2a) oscillation function activates/deactivates.
3.3 - MODE SELECTION
3.3.a - Laundry mode
Press the "Laundry" key (D2), the appliance starts in "CO" (continuous cycle) mode.
The compressor and the fan continue to work independently from the detected level of humidity.
In this mode the fan will work at maximum speed.
3.3.b - Dehumidification mode
Press the "Dehumidification" key (D2), the appliance starts with the percentage of humidity set during
the last use, press the "Setting level of humidity" key (D4) to change it.
3.4 - WATER UNLOADING
3.4.a - Emptying the tank
• When the led "Water tank full" (L9) switches on, the appliance stops, the buzzer rings and it is nec-
essary to empty the tank (7).
• Remove the tank (7) from the appliance body working with both hands (Fig.7).
• Empty the tank (7).
To empty the tank (7) correctly, raise the tab (7b) and let water come out. Before repo-
sitioning the tank (7), close the tab (7b) (figure 8).
• Correctly reposition the tank (7) in the appliance body, otherwise the led (L9) remains turned on and
the appliance doesn't work.
3.4.b - Continuous water unloading
• If desired, it is possible to connect the supplied hose (14) to the connection (13) to continuously drain
water collected by dehumidification.
• Switch off the appliance and disconnect the plug from the power socket.
• Connect the rubber hose (14) with an internal diameter of 10mm to the connection (13) (Fig. 9).
• It is advised to fix the hose (14) to the connection (13) using a clamp (not supplied).
• Correctly reposition the tank (7) in the appliance body making the hose (14) pass in specific seat
located in the tank (7). If this operation is not completed, the led (L9) remains on and the appliance
doesn't work.
Make sure the rubber hose (14) doesn't exceed the exhaust joint height, otherwise wa-
ter will remain in the appliance and could cause a malfunction, damage it and/or cause
dangerous work conditions.
During operation with continuous unloading, do not remove the water tank.
Possible problems caused by the external water drain are not detected by the full tank
alarm. An efficient supervision is necessary in order to prevent malfunctions, damages
to the appliance and/or dangerous work conditions.
EN - 14
Tabla de contenido
