Ventilation Mode (Fan); Heating Mode (Heat); Timer Mode; B-Programmed Switching Off - Olimpia splendid UNICO EASY S1 Instrucciones Para El Uso Y El Mantenimiento

3.9 VENTILATION MODE (FAN)

a. When this mode is selected, the appliance doesn't perform any action both on temperature or on air
humidity in the environment, but only maintains it in circulation.
b. this mode can be selected by pressing the key "MODE" once or more (on the remote control or on the
control panel) until when the specific icon is shown on the display of the control panel and/or of the remote
control.
- icon on the control panel
c. in this mode, the fan is always switched on and it is possible to select its desired speed by pressing the
key "FAN" on the remote control or the key
d. the fan speed is displayed as indicated in paragraphs "3.1" (point SW7) and "3.2" (point d7).

3.10 HEATING MODE (HEAT)

(only for version with heat pump)
a. When this mode is selected, the appliance heats the environment.
b. this mode can be selected by pressing the key "MODE" once or more (on the remote control or on the
control panel) until when the specific icon
c. in this mode, the fan is always switched on and it is possible to select its desired speed by pressing the
key "FAN" on the remote control or the key
the fan speed is displayed as indicated in paragraphs "3.1" (point SW7) and "3.2" (point d7).
d. the temperature set-point is included between 17°C and 30°C (from 62 f and 86 f) with 1°C variations
and it can be set using the keys +/- on the control panel or with the keys ▲ ▼ on the remote control.
e. after a certain time (maximum three minutes) after the activation of the operation mode, the heat pump
activates and the appliance starts delivering warm air.
f. Connect the condensation discharge pipe (paragraph 2.8)

3.11 TIMER MODE

a. this mode allows to program the switching on or the switching off of the appliance.
b. the delay time can be set, activated and cancelled both from the remote control and from the control
panel.
3.11.a Programmed switching on
a. When the appliance is in standby mode, select the operation mode, the desired temperature and ventilation
speed.
- on the control panel:
on the remote control: - press the key "TIMER ON" to access the function and then press the key
-
- icon on the remote control display
on the control panel.
is shown on the display.
on the control panel.
- press and set the switching on delay time with the keys +/-.
- to activate the function, press
the set time on the display stops flashing (the display returns to showing
the environment temperature).
the icon lights up.
"TIMER ON" once or more until the switching on delay time is set.
- Direct the remote control towards the appliance; a beep confirms the acti-
vation of the function.
on the control panel and the indicator "Timer On" on the remote
- the icon
control display light up.
or wait approximately 5 seconds so that
UNICO EASY S1
EN - 19