Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. Use proper grinding angle.
Grind only with the wheel's edge by lifting the grinder
15° to 30°, as shown in Fig. 16.
CAUTION
Do not use the entire surface of the depressed
center wheel. Use only the edge of the depressed
center wheel.
5. Move the grinder in the proper direction.
When using a new depressed center wheel in direction
A (Fig. 16), the wheel edge may cut into the workpiece.
In this case, grind in direction B (Fig. 16).
Once the wheel edge is worn, the workpiece can be
ground in both directions.
A
NOTE
The wheel provided (resinoid wheel) is rated as Class
A grain and # 36 grain size. It is most suitable for
heavy grinding of steel and other types of materials.
6. Adjust operation to desired fi nish.
For a fi ne fi nish, decrease pressure by lifting slightly.
Grind slowly and at the appropriate speed.
CAUTION
The revolving depressed center wheel will create
air turbulence.
Do no lay the grinder down in areas of dust or dirt
until it has come to a complete stop.
15°–30°
B
Fig. 16
DEPRESSED CENTER WHEEL ASSEMBLY
AND DISASSEMBLY
WARNING
Be sure to turned off the switch and pull out the
battery.
1. Assembly
(1) Turn the disc grinder upsidedown so that the spindle
is facing upward.
(2) Align the oval-shaped indentation of the wheel
washer (E) with the notched part of the spindle, then
attach them.
(3) Fit the protuberance of the depressed center wheel
onto the wheel washer (E).
(4) Screw the wheel nut onto the spindle.
(5) While pushing the push button with one hand, lock the
spindle by turning the depressed center wheel slowly
with the other hand.
Tighten the wheel nut by using the supplied wrench as
shown in Fig. 17.
Wheel nut
Depressed center
wheel
Wheel washer (E)
Spindle
Wheel guard
CAUTION
Tighten the wheel nut securely and confi rm that
the depressed center wheel does not wobble.
2. Disassembly
To remove the depressed center wheel, simply
reverse the above-mentioned procedure.
English
Tighten
Wrench
Push button
Fig. 17
19
Tabla de contenido
