APPLICATIONS
○
Finishing of dies for press working, die casting and
moulding.
○
Finishing of thread cutting dies, tools and other small
parts.
○
Internal grinding of tools and machine parts.
○
Burr removal for ceramic ware, tile, and synthetic resin,
fi nish grinding.
WARNING
To avoid the risk of serious injury, NEVER use this
grinder with abrasive wheels, cut-off wheels and/
or saw blades.
Use only with mandrel mounted abrasive stones.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○
How to install the battery.
Align the battery with the groove in tool and slip it into
place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
○
How to remove the battery.
Withdraw battery from the tool while pressing the latch
(2 pcs) of the battery (Fig. 5).
Latch
ASSEMBLY AND OPERATION
Pull out
Insert
Push
Battery
Fig. 5
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○
The power source voltage is stated on the nameplate.
○
The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1.
Connect the charger's power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2.
Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in Fig. 6.
Pilot lamp
3.
Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1- second intervals.) (See
Table 2)
(1) Lamp indication
The indications of the pilot lamp will be as shown
in Table 2, according to the condition of the battery
charger or the battery.
English
Battery
Guide rail
Fig. 6
13